Quadra-Fire CASTILE-CE-MBK 7068-112 Manuel D’Utilisation

Page 24

August 19, 2011

R

7068-112

1.

Chimney & Connector: Use 76mm to102mm diameter

type "L" or "PL" venting system. It can be vented vertically

or horizontally.

2.

  Residential:  The 76mm vertical Top Vent Adapter Kit and

the 76mm to152mm Top Vent Offset Adapter are tested to

use 24 gauge single wall flue connector or Listed double

wall flue connector to Class A Listed metal chimneys, or

masonry chimneys meeting International Conference of

Building  Officials  (ICBO)  standards  for  solid  fuel  appli-

ances.

3.

4.

Exhaust Venting System: Secure to the appliance with

at least 2 screws 180 degrees apart. Also secure all con-

nector pipe joints with at least 3 screws through each joint.

5.  DO NOT INSTALL A FLUE DAMPER IN THE EXHAUST

VENTING SYSTEM OF THIS UNIT.

6.  DO NOT CONNECT THIS UNIT TO A CHIMNEY FLUE

SERVING ANOTHER APPLIANCE.

Vent surfaces get HOT, can cause burns if

touched. Non-combustible shielding or guards

may be required.

ONLY use connector:

•  Within the room, between appliance and ceiling or wall.

Connector shall NOT pass through:

•  Attic or roof space

•  Closet or similar concealed space

•  Floor or ceiling

Maintain minimum clearances to combustibles

Follow Chimney Connector Manufacturer’s

Instructions for Proper Installation.

•  DO NOT CONNECT THIS UNIT TO A CHIMNEY FLUE

SERVICING ANOTHER APPLIANCE.

•  DO NOT CONNECT TO ANY AIR DISTRIBUTION DUCT

OR SYSTEM.

May allow flue gases to enter the house