Quadra-Fire CASTILE-CE-MBK 7068-112 Manuel D’Utilisation

R

August 19, 2011

Page 31

7068-112

1.  Open door to expose the firebox.
2.  Install the left log first and then the right log.

3.  Lean the logs against the cast iron brick in the back of

the firebox.

4.  Push  the  logs  to  the  far  left  and  far  right  against  the

sides of the firebox.

5.  To clean the logs, use a vaccum and a soft brush attach-

ment or a paint brush.

Logs are FRAGILE. Use extreme care when handling or

cleaning logs.

NOTE:

Due  to  the  abrasive  nature  of  a  pellet  appliance  fire,  the

logs are not covered under warranty. Any placement varia-

tion other than shown here can cause excessive heat and

shall void the appliance warranty.

1

.

A 12 volt AC thermostat is required to operate this pellet

appliance. You may use the included wall mount ther-

mostat or purchase an optional programmable thermo-

stat or remote control. It is equipped with an adjustable

heat anticipator. The current rating is .05 amps. The

anticipator needs to be adjusted to the lowest setting

available.

2.  When mounting a thermostat on a wall, be sure to follow

your thermostat installation instructions carefully.

3.  There is a 4 screw terminal block located on the back

lower left corner of the stove directly above the power

cord inlet. The center 2 screws are for the thermostat

wires.

Shock hazard.

•  Do NOT remove grounding prong from plug.

•  Plug directly into properly grounded 3 prong

receptacle.

•  Route cord away from appliance.

•  Do NOT route cord under or in front of appli-

ance.