Nexus 21 Stereo Receiver Multi Control Manuel D’Utilisation

 

MULTI CONTROL 

(Available for analogue 
 

(Available from Multi ve
(ON) = All headings and
(OFF) = All headings an

 be true.  

 
Note a: In the (Goto W ) function, the bearing for every leg will 
always be displayed as tru
 
Note b: The setting is only a
instrument in which is set. 
 
 

Damping of compass he
Controls the response ti
To change damping, press SET.  
To select damping level
d0 (Min) to d9 (max).  
To store the value, pres
Default value is (d0), for use in calm sea. But if the sea is rough, 
you may want to ”stabili
(d1) to (d9).  
Note! Damping is set se

each instrument. 

 

(Auto DEV)  is performed by driving the boat in a circle up to 1¼ 
turn, so that the magnetic deviation can be measured, and by that 
compensated. 
Select calibration code C33 (Auto DEV). 
Drive the boat in a circle for 1 1/4 turn in calm water. When you 
start the circle manoeuvre, press SET.  
 
The un-deviated compass course will be shown in the display as 
you turn. Complete the circle up to 1 ¼ turn.  
When the manoeuvre is ready, press SET to store the deviation 
value. 
If the deviation is corrected (Auto DEV) will be displayed.  
If the deviation is not corrected, an error message will be 
displayed. 
To verify the automatic compass deviation, perform an automatic 
compass check (Auto CHK), (see 12.4.2).  
 

steer pilot instruments, from version 1.3). 

rsion 2.0) 

 bearings will be magnetic.  

d bearings will

P

e bearing. 

ffects the independent Multi Control 

ading.  

me of heading changes.  

, press PLUS and select from: 

 

s SET. 

se” the readout on the display, then select 

parately for 

 

43