Nexus 21 Marine NX2000 Manuel D’Utilisation

 

English

 

VHF NX2000 

 

 

12 

This function scans through each channel sequentially until a signal is detected above 
the squelch level set. Once the signal ends or drops below the squelch level, the Radio 
will continue scanning.  Alternatively, you can instruct the NX2000 to continue scanning 
even if a signal has been detected on any particular channel by pressing the ▲ key 
once. When in Full Scan mode, FS will appear on the bottom line of LCD. 
 
Note that the Radio will not transmit, nor will alternative channels be able to be selected 
while in Full Scan mode. To restore normal operation press (F) key or press channel 
(16) key. 

 

The Memory Scan operates in the same way as the Full Scan, except that it will only 
scan channels that have been entered into the Scan Memory. If no channels have been 
entered into the memory then this function will not be available. 
 
When in Memory Scan mode, “MS” will appear on the bottom line of the LCD.  
 

This function is to tag or cancel tag on a channel, which means select or unselect a 
channel for Memory Scan. If a channel is tagged then the “M” indicator will appear on 
the bottom of LCD. 
To tag a channel, enter the desired channel number on the Microphone controller and 
press “F” on the front panel. Select TAG CH and press “F” again. To delete the tag for a 
channel, repeat the procedure above. 
 

When the (SQ) key on the front panel is pressed, the squelch level bar and “Sq” symbol 
will appear at the right side of the screen as below: