Kanguru Solutions iNAS-100 Manuel D’Utilisation
There are several available options in addition to the basic settings:
Allow entering administration web pages from external network
If this option is not enabled, you will not be able to perform system administration
from the computers connected to the WAN port. You may also assign the HTTP
port number for entering administration web pages.
If this option is not enabled, you will not be able to perform system administration
from the computers connected to the WAN port. You may also assign the HTTP
port number for entering administration web pages.
Disable response to ICMP packets to avoid attacks from hackers
For additional security, when enabling this option, outside computers cannot use
the 'ping' program to probe for IP address of this server.
For additional security, when enabling this option, outside computers cannot use
the 'ping' program to probe for IP address of this server.
• LAN Configuration
If you use the Kanguru iNAS 100 as the gateway to connect to the Internet,
normally there is no need to change the LAN configuration. Simply change the
network configuration of the computers on the LAN to automatically obtain IP
addresses via DHCP protocol. By default, the Kanguru iNAS 100 provides the
NAT function to allow the computers on your LAN to share a single WAN IP
address for Internet access.
normally there is no need to change the LAN configuration. Simply change the
network configuration of the computers on the LAN to automatically obtain IP
addresses via DHCP protocol. By default, the Kanguru iNAS 100 provides the
NAT function to allow the computers on your LAN to share a single WAN IP
address for Internet access.
Fixed IP address
The IP address is a 32-bit digit code used to identify each single entity on a
network. This address will be used for all clients in the internal LAN to access this
Kanguru iNAS 100. You can check the current LAN IP address of the Kanguru
iNAS 100 from the LCD panel (see Appendix A).
The IP address is a 32-bit digit code used to identify each single entity on a
network. This address will be used for all clients in the internal LAN to access this
Kanguru iNAS 100. You can check the current LAN IP address of the Kanguru
iNAS 100 from the LCD panel (see Appendix A).
Subnet Mask
The subnet mask is used to define computer within the same local network. It is
a 32-bits digit code: 255.xxx.xxx.xxx.
The subnet mask is used to define computer within the same local network. It is
a 32-bits digit code: 255.xxx.xxx.xxx.
Default Gateway
The gateway is generally referred as an interchange point that connects two
networks, such as LAN and WAN. You don’t need to configure gateway address
if the NAT function is enabled; just set it as 0.0.0.0.
The gateway is generally referred as an interchange point that connects two
networks, such as LAN and WAN. You don’t need to configure gateway address
if the NAT function is enabled; just set it as 0.0.0.0.
Enable DHCP Server
Once the DHCP server function is activated, the Kanguru iNAS 100 will assign
dynamic IP addresses to any computer in the local network that is configured to
automatically obtain IP addresses.
Note: Only one DHCP server can be activated at any time in a network, or it may
Once the DHCP server function is activated, the Kanguru iNAS 100 will assign
dynamic IP addresses to any computer in the local network that is configured to
automatically obtain IP addresses.
Note: Only one DHCP server can be activated at any time in a network, or it may
cause errors in communication.
• Network File Services
Microsoft Networking
Users using the Kanguru iNAS 100 on the Microsoft Windows operating
systems must start Microsoft Network Services.
Users using the Kanguru iNAS 100 on the Microsoft Windows operating
systems must start Microsoft Network Services.
28