Multiquip Boat MT-62HS Manuel D’Utilisation

3. Move the 

throttle lever to the "IDLE" position (Figure 8).

4. In cold weather, start the rammer  with the 

choke lever in the

"Fully Closed" position (Figure 9).  In warm weather or
when the engine is warm, the unit can be started with choke
halfway or completely open.

This section is intended to assist the
operator with the 

initial start-up of the

MT-62HS rammer. It is extremely
important that this section be 

carefully before attempting to use the
rammer in the field.

DO NOT use your rammer until this section is thoroughly
understood.

Failure to understand the

procedures of the MT-62HS rammer could

result in severe damage to the rammer or
personal injury.

See Figure 1 (Page 13) for the location of any control referenced
in this manual.

The following steps outline the procedure for starting the engine:

1.

Open the  

fuel shut- off valve by moving the fuel  cock

lever to the 

open position (Figure 6).

2.

Turn the engine 

ON/OFF switch  (Figure 7) to the "ON"

position.