Multiquip Boat MT-62HS Manuel D’Utilisation

1. Move throttle lever quickly from the FULL OPEN to IDLE

position  (Figure 13 ) and run the engine for three minutes at
low speed.

2. The MT-62HS  Tamping rammer is designed to run at 3,850

rpm.  At optimum rpm the foot hits at the rate of 600~690
impacts  per  minute.  Increasing  throttle speed past factory
set rpm does not increase impacts and  may damage unit. The
MT-62HS  is designed to advance while tamping. For faster
advance, pull back slightly on the handle so that rear of foot
contacts soil first.

1. To start  the rammer tamping action, move the throttle lever

(Figure 12) 

quickly from IDLE (close) to the FULL OPEN

position.  DO NOT move the throttle lever slowly as this may
cause damage to the clutch or spring.

2. After the engine 

cools, turn the engine ON/OFF switch to the

“OFF” position (Figure 14).

1. Move the throttle lever quickly to the 

IDLE  position, and turn

the engine ON/OFF switch to the 

OFF position.  Turn the fuel

valve lever to the 

CLOSED position.

Make sure that the throttle lever is moved to the
FULL OPEN position. Operating the rammer

at less than full speeds can result in damage to

the clutch springs or foot

3. Close the 

fuel shut- off valve (Figure 15) by moving the fuel

cock lever to the CLOSED position.