Multiquip Appliance Trim Kit MVH-402GHB Manuel D’Utilisation

1. Replace engine oil, first in 25 hours of operation and every

50 to 100 hours afterwards.

2. Drain the engine oil when the oil is 

warm as shown in

Figure 22.

3. Remove the oil drain bolt and sealing washer and allow

the oil to drain into a suitable container.

4. Replace engine oil with recommended type oil as listed

in Table 3. Engine oil capacity is 1.16 quarts (1.1 liters).
DO NOT overfill.

5. Install drain bolt with sealing washer and tighten se-

curely.

1. Remove the air cleaner cover and foam filter element as

shown in Figure 23.

2. Tap the paper filter element (Figure 23) several times on a

hard surface to remove dirt, or blow compressed air [not
exceeding 30 psi (207 kPa, 2.1 kgf/cm

2

)] through the filter

element from the air cleaner case side.

 NEVER  brush off dirt.

Brushing will force dirt into the fibers. Replace the paper filter
element if it is excessively dirty.

3. Clean foam element in warm, soapy water or nonflammable

solvent.  Rinse and dry thoroughly.  Dip the element in clean
engine oil and completely squeeze out the excess oil from the
element before installing.

NEVER attempt to check the V-belt with the
engine running. Severe injury can  occur if your
hand gets caught between the V-belt and the
clutch (Figure 24). Always use safety gloves.

CLUTCH

PULLEY

VIBRATOR

PULLEY

1. Remove and clean the spark plug (Figure 21).

2. Adjust the spark gap to 0.028 ~0.031 inch (0.6~0.7 mm). This

unit has electronic ignition, which requires no adjustments.