Lucent Technologies Window SLV 9124 Manuel D’Utilisation

Configuration

9124-A2-LB20-00

March 2000

5. Select the

 Delete EDLCI Connections and Make a Mgmt Only

 option.

PVC connections for the selected DLCI are broken, the Port-1 DLCI mapped
to this network DLCI and the embedded management DLCI (EDLCI) are
deleted, and the selected DLCI will be reconfigured as a management PVC
using the Node IP Address.

See Table 3-9, 

Using this special feature, you can set up two FrameSaver units that are
connected back-to-back without frame relay switches between them, as in a
test bench setup.

When setting up back-to-back operation:

H

One unit must be configured for Standard operation, which is the setting for
normal operation.

H

The other unit must be configured for Back-to-Back operation so it presents
the network side of the UNI (user-network interface).

Only one of the units will have its operating mode changed.

"

To set up back-to-back operation:

1. On the unit to be configured for Back-to-Back operation, manually configure

DLCIs; DLCIs should be configured before connecting the two units.

2. Access the Change Operating Mode screen.

→

→

3. Select Back-to-Back Operation, and respond Yes to the 

prompt.

4. Save the change.

"

To return the unit to normal operation:

1. Return to the Change Operating Mode screen and switch back to Standard

Operation.

2. Respond Yes to the prompt and save the change. The units can be

reconnected to a standard frame relay network.