Leica TPS - System 1000 1000Z01 Manuel D’Utilisation

TPS-System 1000 Programs-2.3.1en

© Leica

There are two methods that can be used to create the
necessary data files. If the program called "FILE
EDITOR" is loaded into the theodolite, all necessary
data for a given component can be entered through the
keyboard. To enter data on the computer a DOS pro-
gram called "ROADDATA.EXE" can be used. If you
create the files using the "ROADDATA.EXE" program,
the files must be copied to the PCMCIA card in a
directory called GSI.

The following table shows an overview of the max. file
sizes:

Type of file

Limitations

Horizontal
alignment

No limitation for "RoadPlus";
max. 200 blocks for "File Editor"

Vertical
alignment

No limitation for "RoadPlus";
max. 200 blocks for "File Editor"

Cross section

200 data blocks
(number of points in a cross section
max. 48)

Cross section
assignment

100 data blocks

Station equation

100 data blocks

"ROADPLUS" allows measurements in one telescope
position only. A typical "ROADPLUS" session includes
the following steps:

1. Enter setup information for the instrument and orient.
2. Start the ROADPLUS program and configure.
3. Select the alignment files
4. Select a station
5. Pick a point on the cross-section to stakeout, enter an

offset, choose method.