Leica TPS - System 1000 1000Z01 Manuel D’Utilisation
254
TPS-System 1000 Programs-2.3.1en
© Leica
IV
EL
AH
OH
BS
SM
AS
FS
BL
HB
KM
FB
SA
PZ
LB
TB
CO
RP
Configuration
Start the "Configuration-Editor" from the "SELECT
ALN FILES" dialog.
ALN FILES" dialog.
ROAD+\ CONFIGURATION
14:03
MC
INFO
DFLT
EDIT
3D Stake
:
ON
Crs.Intrpl.
:
OFF
Crs.Movemnt
:
Left > Right
Hinge mode
:
normal
Log File
:
ON
Log FlName
:
ROAD.LOG
Base Chainge : Enter the beginning chainage for the
project
End Chainge : Enter the ending chainage for the
project
Chainge Incr : Enter the chainage interval to be used
Hght. Shift
: Enter a vertical shift value if needed.
The value entered will be applied to
the whole alignment.
the whole alignment.
Deflct. Tol.
: Enter an angle tolerance for deflection
angles. Make this a small value but
not 0.
not 0.
Chainge Tol. : Enter a value for chainage tolerance.
This value will determine how close
the point will be to a 0 location.
the point will be to a 0 location.
3D Stake
: Use the
key to toggle between
OFF or ON. For cut/fill capability this
should be set to ON.
should be set to ON.
Base Chainge :
0.000
End Chainge
:
89.270
Chainge Incr :
10.000
m
Hght. Shift
:
0.000
m
Deflct. Tol. :
0°00'16"
Chainge Tol. :
0.010
m
F1
F2
F3
F4
F5
F6
HELP