IntraServer Technology ITIpci 5100G/GF Manuel D’Utilisation
LSI Logic Corporation
Page 27 of 56
iti # cat /etc/hostname.alt0
iti-1
iti # cat /etc/hostname.alt1
iti-2
iti # cat /etc/hostname.alt2
iti-3
iti # cat /etc/hostname.alt3
iti-4
iti-1
iti # cat /etc/hostname.alt1
iti-2
iti # cat /etc/hostname.alt2
iti-3
iti # cat /etc/hostname.alt3
iti-4
3. For each host name, enter the appropriate IP address in the
/etc/hosts
file.
4. Reboot the system.
If you make changes and put the system into service before rebooting, you
may experience configuration problems.
may experience configuration problems.
Perform this command to reboot the system:
# reboot -- -r
Configuring Driver Parameters
with ndd
with ndd
The ndd (1M) utility is useful for changing configuration parameters for the
adapter. Alternately, adapter parameters can be changed by manually editing
the configuration files. This section describes the ndd utility in detail.
adapter. Alternately, adapter parameters can be changed by manually editing
the configuration files. This section describes the ndd utility in detail.
Note: Any changes made with
ndd
are temporary and will be lost when
you reboot the system. To make configuration changes survive the reboot
process, you will need to store driver settings in the
process, you will need to store driver settings in the
/etc/rc2.d/S99itialt
file (see Saving Driver Parameters Beyond
Reboot).
Available Parameters
To view parameters that you can set using the ndd command, type:
# ndd /dev/alt '?'
The system returns the following:
stat_ticks (read and write)
send_max_coalesced_bds (read and write)
send_coal_ticks (read and write)
recv_max_coalesced_bds (read and write)
send_max_coalesced_bds (read and write)
send_coal_ticks (read and write)
recv_max_coalesced_bds (read and write)