IntraServer Technology ITIpci 5100G/GF Manuel D’Utilisation
LSI Logic Corporation
Page 25 of 56
# sync
# sync
# halt
# sync
# halt
Then, at the ok prompt, use the following command to list the system
devices:
devices:
ok show-devs
ITI-5100G/GF adapter output will be displayed. Sample PCI examples are
shown on the next page.
shown on the next page.
For PCI systems, " ethernet@1 " identifies the PCI ITI-5100G/GF
adapter:
adapter:
/SUNW,ffb@1e,0
/SUNW,UltraSPARC-II@0,0
/pci@1f,2000
/pci@1f,4000
/counter-timer@1f,1c00
/virtual-memory
/memory@0,60000000
/aliases
/options
/openprom
/chosen
/packages
/pci@1f,2000/ethernet@1
/SUNW,UltraSPARC-II@0,0
/pci@1f,2000
/pci@1f,4000
/counter-timer@1f,1c00
/virtual-memory
/memory@0,60000000
/aliases
/options
/openprom
/chosen
/packages
/pci@1f,2000/ethernet@1
/pci@1f,4000/scsi@3
/pci@1f,4000/network@1,1
/pci@1f,4000/ebus@1
/pci@1f,4000/scsi@3/tape
/pci@1f,4000/scsi@3/disk
/pci@1f,4000/ebus@1/SUNW,CS4231@14,200000
....
/pci@1f,4000/network@1,1
/pci@1f,4000/ebus@1
/pci@1f,4000/scsi@3/tape
/pci@1f,4000/scsi@3/disk
/pci@1f,4000/ebus@1/SUNW,CS4231@14,200000
....
If the appropriate ITI-5100G/GF device is not listed, check that the adapter is
installed and properly seated. Then restart the system and re-install the
adapter software.
installed and properly seated. Then restart the system and re-install the
adapter software.
Configuring the Host Files
Once the ITI-5100G/GF adapter software is installed on your system, it must
be configured. To ensure proper adapter performance, configure the host files
and driver parameters as described in the following sections.
be configured. To ensure proper adapter performance, configure the host files
and driver parameters as described in the following sections.