iHome iHC5 Manuel D’Utilisation

Using the iHC5

Resetting the Alarm to Come on the Next Day

a) When the alarm is sounding, press the Alarm Reset/Power/End Button  to stop the alarm and reset it to come

on the following day.

Snooze

a) Press the Snooze/Dimmer Button  after the alarm sounds. The alarm will be silenced and come on again

about 9 minutes later. Snooze can be pressed several times during the 1 hour alarm cycle.

Sure Alarm

The iHC5 has a sure alarm feature. If the backup batteries are installed, the buzzer alarm will still sound in the event

of a power failure.

Listening to Radio

Setting up the Antennas

a) An internal AM antenna is built into the unit; rotate the unit as needed for best AM reception.

b) Extend the wire FM antenna fully for best reception. Do not strip, alter or attach to other antennas.

Tuning and Playing the Radio

  a) Press the Mode Button  to select AM, FM1 or FM2 radio band.
  b) Press  Up or Down  Button to tune the radio to a desired station in the selected band.
  c)  To memorize the current station as a preset, press and hold Preset Button  1, 2, 3 or 4. Repeat step 1-3 to preset

up to 12 stations (4 AM and 8 FM). To listen to a preset station at any time, select the desired band and press the

desired preset button  .

d) Press the Volume +  or Volume -  on main unit or remote control to adjust the system volume.
e) To turn off the iHC5, press the Alarm Reset/Power Button/End  on the main unit or remote control.

Listening to Bluetooth Music Devices (with A2DP and AVRCP profiles)

Before you can play Bluetooth music through the iHC5, you need to pair and link your Bluetooth device with the iHC5.

Pairing and Linking your Bluetooth Device with the iHC5:

a) Make sure your Bluetooth device is fully charged

b) Power Up your Bluetooth device and connect your iHC5 to AC adaptor.

c) Turn on Bluetooth functionality on your Bluetooth device. Typically, Bluetooth controls are found on the

device’s tools or settings menu (see your user manual). Turn on Bluetooth connectivity.

d) Press the Power button on the iHC5 to put it in pairing mode. The Bluetooth icon and “pairing” icon on the

iHC5 will flash.

e) Choose “add a new Bluetooth device” on your device. It will start to search. If the pairing attempt fails or “times

out”, press and hold the Play button on the iHC5 for 4 seconds to restart the process, and repeat “add a new

Bluetooth device” on your Bluetooth device.

f) After your device and the iHC5 have discovered each other, you will be asked to enter a passcode on your

Bluetooth device. The passcode for the iHC5 is: 1234

g) A “Pairing Successful” or similar message should appear on your device and the Bluetooth icon on the iHC5

should stop flashing, followed by a confirmation beep.

h) Pairing will remain intact even if either or both devices are powered off or are taken out of link range (~30 feet).

However, the active link between the devices will be lost and need to be re-established.

i) To re-establish a link, select iHC5 from the Bluetooth devices menu on your Bluetooth device and press the Talk

or Play button on the iHC5 or Remote Control.