Siemens ET130501 Manuel D’Utilisation
An oven must have power ventilation to install a hob
above it. Check the oven’s dimensions in its installation
manual.
above it. Check the oven’s dimensions in its installation
manual.
Preparing the kitchen unit
If there is no oven below the cooking hob, place a non-
inflammable separator (e. g. metal or plywood) 10mm
from the bottom of the cooking hob. This will prevent
access to the base of the hob.
On wood work surfaces varnish the cutting surfaces with
a special glue. This protects them from water vapour
which could collect under the work surface.
inflammable separator (e. g. metal or plywood) 10mm
from the bottom of the cooking hob. This will prevent
access to the base of the hob.
On wood work surfaces varnish the cutting surfaces with
a special glue. This protects them from water vapour
which could collect under the work surface.
Hob installation
The adhesive joint prevents water seepage. If it is
If it is not factory installed, adhere the joint supplied on
Remove the clamps from the bag provided.Gently
Insert the cooking hob. Press the sides of the hob until
it is supported around its entire perimeter. Center it in
it is supported around its entire perimeter. Center it in
Turn the clamps and proceed in reverse order to the
Electrical connection
Check that the power and voltage of the appliance
given on the specifications plate are compatible with
the electrical installation.
given on the specifications plate are compatible with
the electrical installation.
The cooking hobs are supplied with a power cable
with or without a wall socket plug.
Appliances with plugs must only be connected to
sockets that have earth wires correctly installed.
with or without a wall socket plug.
Appliances with plugs must only be connected to
sockets that have earth wires correctly installed.
17
Make the appropriate size cut in the work surface. Fig. 4.
the underside of the cooking hob. Fig. 6.
factory installed (depending on model), do not move it.
the insertion space. Fig. 8.
screw the clamps into the holes indicated. Fig. 7.
installation. Fig. 9.