HP C4392-90100 Manuel D’Utilisation

■

If you cannot find the CD-Writer Plus drive in Explorer, restart your 
computer, or shut it down and then turn it on again.

■

Is the CD-Writer Plus drive receiving power? (Test this by opening and 
closing the tray by pressing the eject button on the front of the drive.)

■

Turn off and unplug your computer.

Double-check each connector along the data cable. The connectors 
are inserted properly when all pins are covered and the colored stripe 
on the side of the data cable lines up with PIN-1 of each connector.

■

If you are sharing the IDE data cable between the CD-Writer Plus 
drive and another device, did you change the data-cable (middle/end) 
connector attached to the device that was already inside your 
computer? Did you follow the Install Recommendation Printout’s 
instructions for the jumper setting on page 1-4 (installation in an 
empty drive bay) or page 1-21 (CD-ROM replacement)?

If you switched the data cable connector on the other device, change 
it back to the original position. A device attached to the end 
connector of the data cable to begin with, should be attached to the 
end connector after installing the new drive. If it was originally 
attached to the middle connector, it should remain attached to the 
middle connector. The other device may be jumpered to Cable-select 
rather than Master or Slave. If this is true, the location of the data-
cable connector (middle/end) is very important.

The CD-Writer Plus drive will have a drive icon just like a CD-ROM drive 
icon. You can determine which icon is your CD-ROM drive and which 
icon is your CD-Writer Plus drive by double-clicking on the My 
Computer icon, right-clicking on the CD drive’s icon, and selecting 
Eject. The tray of the selected drive will open.

■

Turn off and unplug your computer.

■

Make sure that the power cables are securely attached to both devices.