HP C4392-90100 Manuel D’Utilisation

■

If you are sharing the IDE data cable between the CD-Writer Plus 
drive and another device, did you change the data-cable (middle/end) 
connector attached to the device that was already inside your 
computer?

If yes, change the data-cable connector location back to the original 
position. The other device may be jumpered to Cable-select rather 
than Master or Slave. If this is true, the location of the data-cable 
connector (middle/end) is very important.

■

For Sony and Goldstar CD-ROMs, try configuring the CD-Writer Plus 
as Master and the CD-ROM as Slave.

See Minimum System Requirements on page A-1. 

■

There is no CD in the CD-Writer Plus drive. Insert a CD and try again.

■

After inserting a CD, you need to wait a moment to let the CD-Writer 
Plus drive read the disc information (wait until the light on the front 
of the drive stops flashing and stays green), then click on the CD-
Writer Plus drive’s icon again.

■

The CD may be in the tray upside-down or a little off-center; try 
reinserting the CD. The label should be facing up.

■

You are trying to read from a blank recordable CD. Try again after 
copying some information to the CD.

■

Make sure the jumper on the CD-Writer Plus is set as advised in the 
Install Recommendation Printout for your computer (see page 1-21 
and page 1-25).

■

Check the data cable and make sure the cable’s colored edge is aligned 
with PIN-1 on the CD-Writer Plus drive (see page 1-27).