Gerber Tools Saw 600 Manuel D’Utilisation

2 – 4

If no medium has been loaded, the message below appears on the display, prompting the loading of a
medium.

If a medium has already been loaded, the current media setting is displayed as shown below.

Select the media mode to suit the medium used. For instructions on loading media and selecting the media
mode, see “2.3 Loading the Medium.”

Load the medium, aligning it with the right-hand grit roller when viewed from the front so that it registers
with the media sensor. Then, adjust the push-roller position to match the width of the medium. The cutting
plotter  can  use  media  in  roll  or  sheet  form.  Load  the  desired  medium  type  by  following  the  appropriate
instructions.

Load the roll medium onto the stand stock rollers.

Fit the stoppers to one of the stock rollers (loosen the screws on the stoppers first).

Stoppers

Stock roller