Gerber Tools Saw 600 Manuel D’Utilisation

3 – 2

Before data is sent from the computer, the format (command mode) of the data sent by the application soft-

ware must be checked. The cutting plotter accepts two data formats (command modes): GP-GL (Graphtec)

and HP-GL commands. Set the command mode to suit the application used.

■ Setting the Command Mode

Check to confirm that the cutting plotter is in READY mode (displaying the current pen settings).

Press the 

 (PAUSE) key to switch to PAUSE mode, and then press the 

 (NEXT) or 

 (PREV.) key

until the menu shown below is displayed.

Press the 

 (ENTER) key to display the menu shown below.

Press the 

 or 

 key to select “GP-GL” or “HP-GL,” and then press the 

 (ENTER) key to confirm.

To cancel the selection, press the 

 (NEXT) or 

 (PREV.) key.

If “GP-GL” is selected, set the STEP SIZE. If “HP-GL” is selected, set the ORIGIN POINT. If a different

command from that set previously is selected, the PAUSE mode is automatically cancelled once the STEP

SIZE (GP-GL) or ORIGIN POINT (HP-GL) is set.