Gerber Tools Saw 600 Manuel D’Utilisation

4 – 51

Reducing this setting increases image quality by enabling smooth cutter-blade tip control when arcs are

cut. The STEP PASS setting specified is used as the unit for blade tip control, with blade tip control omitted

for any data below the STEP PASS setting. If the STEP PASS setting is too high, the image cut may not be

faithfully reproduced. Normally, the STEP PASS setting should be set to “1.”

Press the 

 (PAUSE) key to switch to PAUSE mode.

Press the 

 (NEXT) or 

 (PREV.) key until the following menu is displayed.

Press the 

 (ENTER) key to display the step-pass setting menu.

Use the 

 or  

key to select the required value within the range of “0” to “20,”

and then press the 

 (ENTER) key to confirm. To cancel the selection, press the

 (NEXT) or 

 (PREV.) key.

Press the 

 (PAUSE) key to cancel PAUSE mode.

This setting is retained in the internal memory even when
the power is turned off.