Emulex Computer Drive 355 Manuel D’Utilisation

I

N

S

PEED

™ SAN S

TORAGE

 S

WITCH

 M

ODEL

 355

C

HAPTER

 2 S

WITCH

 I

NSTALLATION

U

SER

’

S

 G

UIDE

8

4.

Using a No. 2 Phillips screwdriver, attach the switch(es) to the tray by installing the 4 thread 
forming screws (6-32 x 1/4 100

°

) into the aligned holes.

5.

Turn the tray over with the attached switch(es) now on the top of the tray.

Install the tray with the switch(es) attached into a rack following the instructions provided with the rack 
mount kit.

When installing equipment in a rack, give careful consideration to the following factors:

•

The operating ambient temperature of rack-mounted equipment must not exceed the maximum 
rated ambient temperature, which is indicated in this installation guide. (See “Operating 
Conditions” on page 61.)

•

The air flow clearances specified in this installation guide must be maintained within the rack. 
(See “Operating Conditions” on page 61.)

•

The AC supply circuit for rack-mounted equipment must be capable of supplying the total current 
specified on all the labels of the rack-mounted equipment.

•

All AC power supply connections must be properly earthed. To ensure the integrity of the earth 
connection, special attention must be given to connections that are not directly connected to the 
branch circuit (for example, power strips).

•

The rack-mounting hardware has been carefully selected to properly support the equipment. 
Any alternate rack-mounting hardware must provide equal or superior support.

Note: While there are eight holes on each side of the tray, only the four holes indicated on 

each side of the tray in Figure 2-1 should be used for the switch.

Figure 2-1: Diagram Depicting Switch Installation into Tray (Note: Switches and tray are displayed 
upside-down to facilitate proper installation.)