Emerson DECT 6.0 EM6113 Manuel D’Utilisation

7

2. 

Plug one end of the telephone line cord into the TEL LINE jack on the back of the base

    and the other end into a modular jack. 

3. Plug the AC power converter into the electrical outlet and the DC connector into the

    jack on the back of the base. 

4. Place the handset in the base cradle. The charge/in use voice mail indicator turns on,

    verifying the battery is charging.

1. 

Choose an area near an electrical outlet and a telephone wall jack (RJ11C), and place

    your cordless telephone on a level surface, such as a desktop or tabletop, or you may

    mount it on the wall. 

Modular phone wall jack

Main power outlet

Replace the 

cover

Install the

battery pack

Press the          button. 
During a call you can adjust the volume from 1 to 5.

Press the          button.
During a call you can switch your handset’s microphone off.  The display shows          .
To unmute press the           again.

Your handset saves the last 3 dialed telephone numbers

   The handset is in idle state
Press the          button repeatedly (if necessary) until the desired telephone number is 
displayed.  
Press the          button.  The phone number is being dialed.

When you press the        button and hear the dialing tone, the very last dialed telephone 

number is dialed by pressing the             button.

REDIAL

REDIAL

16

Press the          button, to answer a call.  

Enter the phone number, using telephone key pad.  Delete wrong characters by pressing 

the          button.  Press and HOLD the         button to delete entire entry.

Press the           button , and the phone number is being dialed.  

You can also press the           button, and you will hear the dialing tone.  The entered 

number will be dialed immediately.  It is not possible to correct wrong digits individually 

using this dialing procedure. 

Press the          button or replace the handset in the base station.

Your handset automatically times the duration of every call.  

During a call operation you can switch On/Off the speaker. 
Press the           button.  The           appears in the display when the speaker is ON.

CID

Open the battery compartment cover, install the battery  and replace the battery

cover.

: :  Use only power adaptors and batteries supplied with this

product.  To order a replacement please call customer support :

1-877-768-9483 or online: www.emersonphones.com

Before the handset is used for the first time, insert it in the base 

station / charging station for at least 16 hours.

The handset warms up during the charging process. This is normal and

does not represent a risk. The battery status is shown on the display. When the

battery capacity is nearly exhausted, the battery symbol will flash in the display.

End your call and place the handset into the base or charging station for

charging.

After a short time, the battery symbol will appear to be fully charged but this is

actually not the case. The battery capacity will decrease rapidly. We advise

you to put the handset on the base unit for 12 hours so that it can be

recharged completely.