EMC Network Cables P/N 300-002-803 Manuel D’Utilisation

EMC Host Connectivity with QLogic FC and iSCSI HBAs and FCoE CNAs for the Linux Environment

An example of the console output reported by the driver removal 
is as follows:

3. Verify that the 

/etc/modprobe.conf

 file contains the information 

necessary for the server to boot and that a new ramdisk has been 
created. If the ramdisk has not been created as in the example 
above, create one.

where $1 is the currently running v2.6.x kernel version.

Example:

4. Reboot the host.

This section provides guidance for uninstalling the QLogic v7.xx.xx 
driver RPM. The QLogic RPM may be used to remove the driver with 
the e switch for the RPM command.

The following are example steps:

1. Verify the currently loaded QLogic driver RPM:

[root@l82bi235 extra]# rpm -qa | grep qla
qla2x00-v7.03.00-1

2. Remove the driver using the RPM command:

[root@l82bi235 extra]# rpm -ev qla2x00-v7.03.00-1

3. Verify that the 

/etc/modules.conf

 file contains the information 

necessary for the server to boot and that a new ramdisk has been 
created. If the ramdisk has not been created, create one:

where $1 is the v2.4.x kernel version currently running.

Example: