CTC Store IPDSLAM-A8/A16 Manuel D’Utilisation

 
 

                                                                 

 

109 

executing TFTP to ADSL IP DSLAM.   

Example 

IPDSLAM# upgrade enable 
Yes or No <y/n>? y 
System is in the “upgrade” mode now. You could start to upgrade the 
system file. 

Note: This step can be skipped, in case of without Ethernet-VLAN on each 

port. 

Step 3: Enter the command “ show sysip” to get the <IP address> of ADSL IP 

DSLAM. If you already know the IP address, you can skip this step. 

Example 

IPDSLAM# show sysip 
IP: 192.168.10.2 
Submask: 255.255.255.0 
Gateway: 192.168.10.1 

Note: Make sure that the system IP and your computer is in the same subnet. 

Step 4: Open another window interface, e.g., MS-DOS interface. 
Step 5: Enter the command “tftputil <IP address> <get> <sf_user.cfg>” under 

the directory of configuration file and control files. 

Example:  

c:\> tftputil 192.168.10.2 get sf_user.cfg 

When uploading, three LEDs, “MAINT” “ALARM” and “FAULT”, will 
blink. Unless you finish uploaded, do not shut down ADSL IP DSLAM. 

Step 6: Restart the system in terminal emulation interface. The system will 

restart according to your “sf_user.cfg”. 

Example 

IPDSLAM# restart 
Yes or No <y/n>? 
System is restarting now.Wait….. 

Describes how to restore your configuration settings from computer to ADSL IP 

DSLAM. The following procedures will help you to restore configuration:   

Step 1: Open the hyber terminal interface in order to execute CLI. 

Step 2: Enter the command “ show sysip” to get the <IP address> of ADSL IP