Futaba 10CAG Manuel D'Instructions

62

ELEV-FLAP

mixing (ACRO

GLID):

ELEV-FLAP

PL[LQJLVWKH¿UVWSUHSURJUDPPHGPL[ZH OOFRYHU7KLVPL[PDNHV

WKH ÀDSV GURS RU ULVH ZKHQHYHU WKH ELEVATOR STICK is moved. It is most 
commonly used to make tighter pylon turns or squarer corners in maneuvers. In 
PRVWFDVHVWKHÀDSVGURRSDUHORZHUHGZKHQXSHOHYDWRULVFRPPDQGHG

Adjustability:
• Rate

  IXOO XS ÀDS WR  IXOO GRZQ ÀDS ZLWK D GHIDXOW RI 

RQHKDOIRIWKHÀDSUDQJHLVDFKLHYHG when the ELEVATOR STICK is pulled 
to provide full up elevator.)

• Switch: fully assignable. Also LOGIC SW (Lsw1 to 3) may be assigned. Set up 

LOGIC SW

: See p. 38.

*IF you set it to NULL, the mix does not work. (ACRO)

•Range (GLID): The range that mixing does not work near neutral of an elevator 

stick can be set up. 

  Hold the stick to the desired point (upper or lower side) , then press DIAL and 

hold one second to set the range.

• Condition (GLID): Separate ELEV-FLAP settings for each condition can be set.

(ACRO)

(GLID)

Activate  ELEV-FLAP mixing. Adjust flap 
travel to 0%

ÀDSVZLWKQHJDWLYHHOHYDWRU

(push) and 45% flaps with positive 
elevator.

Open the ELEV-FLAP function.

for 1 second.

 (If BASIC,

again.)

to ELEV-FLAP.

Activate the function.

to MIX.

to ACT.

Adjust the travels as needed. 
(Ex: 0%,to 45%.)

to RATE.

ELEVATOR STICK.

to 0%.

ELEVATOR STICK.

to 45%.

Close menu.

$GMXVWÀDSHURQV ÀDSWUDYHODYDLODEOHFLAPERON): see p. 52.
Set up AIRBRAKE

FURZEXWWHUÀ\VHHS

Set up programmable mixes (ex: FLAP-ELEVATOR): see p. 68. 
View additional setups on the internet: www.futaba-rc.com\faq\.