Chief Personal Lift SL220 Manuel D’Utilisation
Installation Instructions
SL220
11
Figure 14
5.
While still pulling the projector cradle away from the sides of
the SL220, slide front channels towards back, off of
bearings and remove projector cradle from SL220. (See
Figure 15)
the SL220, slide front channels towards back, off of
bearings and remove projector cradle from SL220. (See
Figure 15)
Figure 15
PLACING SL220 INTO CEILING STRUCTURE
1.
Orient SL220 so that the rear of the SL220 (with the
electrical opening) lines up with the outlet box attachment
plate (H) on the SL220 frame. (See Figure 16)
electrical opening) lines up with the outlet box attachment
plate (H) on the SL220 frame. (See Figure 16)
2.
Lift SL220 (A) into place through the SL220 frame (B). (See
Figure 16) Ensure that there are four audible clicks---each
corner hook "clicking" into place onto the frame. (See
Figure 17)
Figure 16) Ensure that there are four audible clicks---each
corner hook "clicking" into place onto the frame. (See
Figure 17)
3.
Lower onto SL220 frame, carefully lining up outlet box
attached to SL220 frame, with opening at rear of SL220.
(See Figure 17)
attached to SL220 frame, with opening at rear of SL220.
(See Figure 17)
4.
Secure the SL220 (A) to the SL220 frame (B) using four
8-32 x 1" Phillips head screws (L), two in the front and two
in the back of the SL220. (See Figure 17)
8-32 x 1" Phillips head screws (L), two in the front and two
in the back of the SL220. (See Figure 17)
5.
Secure the outlet box attachment plate (H) to the SL220
using one 8-32 x 1" Phillips head screw (L). (See Figure 17)
using one 8-32 x 1" Phillips head screw (L). (See Figure 17)
Figure 16
Figure 17
3
Front of SL220
3
Front Channel
Bearings
Bearings
3
3
Front Channels
4
Rear of
SL220
SL220
Front
Channels
Channels
Rear of
SL220
SL220
(H)
2
(B)
Electrical
Opening
Opening
(A)
5
(L) x 1
3
4
(L) x 4
2
Corner
Hook
Hook
(A)
(B)
3