Avital 4103 Manuel D’Utilisation

Neutral safety switch interface

Some vehicles do not have an electrical neutral safety switch. Instead,
the ve hicle has a mechanical neutral safety switch that physically in-
terrupts the starter wire and is used when the vehicle is in any drive
gear. If the remote start is interfaced before this switch, it will provide
protection from starting in gear. However, some vehicles combine the
column shift mechanism and the mechani cal neutral safety switch into
one mechanical part.

Note:

You must complete the remote start system installation before do-

ing the following test. Ensure that the remote start system is functioning
normally. This includes connecting to the brake as a shut-down.

Testing the neutral safety switch

1. Make sure there is adequate clearance to the front and rear of the

vehicle because it may move slightly.

2. Make sure the hood is closed and there are no remote start shut-

downs active.

3.  Set the emergency brake.
4.  Turn the key to the “run” position, this will release the shifter.
5.  Place the car in drive (D).
6.  Place your foot directly over the brake pedal, but do not depress

it. Be ready to step on the brake if the starter engages.

7. Activate the remote start system.
8. If the starter engages, immediately depress the brake to shut the

remote start system down. If the starter does not engage, no ad-
ditional safety system is required.

If the starter engages and the vehicle is a General Motors product or
Dodge Dakota pickup, you can find an alternative shut-down method
to prevent the starter from engaging. Refer to

www.directechs.com

for

Document 1008 under the Resource tab. If the vehicle is not a Gen-