Antunes, AJ VCT-1000 Manuel D’Utilisation

P/N 1010807 Rev. E 06/06

VERTICAL CONTACT TOASTER

Figure 2. Installing Bun Chute

Bun Chute

Yellow

Support

Rod

Hook Bun Chute over rear

bottom conveyor cover

yellow support rod

Figure 1. Toaster and Accessories

Heat

Shield

Heat

Shield

Conveyor

Cover Assy.

(rear)

Yellow Support

Rod (front)

Conveyor

Cover Assy.

(rear)

Bun Feeder.

Conveyor

Cover Assy.

(front)

Unpacking

1. Remove unit and all packing materials from ship-

ping carton.

2. Open the large box. It should contain:

• Bun Feeder (Figure 1).

• Bun Chute (Figure 2)

• 2 Release Sheets (Figure 1).

• Authorized Service Agency Directory

• Owner’s Manual

3. Remove all packing materials and protective cov-

erings from the unit and parts.

NOTE: If any parts are missing or damaged, con-

tact Antunes Technical Service IMMEDIATELY at

1-877-392-7854.

Assembling the Unit

NOTE: The factory has pre-installed a Release

Sheet over the Platen (Figure 1). Verify that it is

properly in place before proceeding.

1. Install the Bun Feeder (Figure 1) and Bun Chute

(Figure 2).

IMPORTANT: Make sure Heat Shield Assembly

is properly seated and engages the Conveyor

Interlock Safety Switch (see Figure 1). The con-

veyors will not rotate unless the Heat Shield is in

place and correctly engages the Conveyor Interlock

Safety Switch.

NOTE: Check the Release Sheet to make sure it

is not caught in the conveyor. Additional Release

Sheets can be obtained through your authorized

service agency under part no. 7000249 (3 pack) or

7000250 (10 pack).

INSTALLATION

Release

Sheet

Yellow

Support Rod

(rear)

Bun

Feeder

Conveyor

Cover Assy.

(rear)

Shown without option-

al Roller Tensioners

and Belt Wraps.

Shown without optional

Roller Tensioners and

Belt Wraps.

CAUTION

Failure to use Release Sheets may result in damage

to the unit and loss of warranty coverage.

Rear

Conveyor

Belt Chain

Front Conveyor

Belt Chain

Platen

Conveyor

Interlock Switch