B&B Electronics Switch RS-485 Manuel D’Utilisation
485SDA103798 Manual
3
B&B Electronics -- 707 Dayton Rd. -- PO Box 1040 -- Ottawa, IL 61350
PH (815) 433-5100 -- FAX (815) 434-7094
Windows 3.11
1. Insert SDA Logger installation disk in your floppy drive.
2. Click the File Manager button.
3. Select the floppy drive containing the SDA Logger
2. Click the File Manager button.
3. Select the floppy drive containing the SDA Logger
installation disk.
4. Double click the Setup.exe icon when it appears.
5. Follow the installation instructions as prompted.
5. Follow the installation instructions as prompted.
Windows 9x and Windows NT
1. Insert the SDA Logger installation disk in your floppy drive.
2. Click Start | Run.
3. Click the Browse button and choose the floppy drive
2. Click Start | Run.
3. Click the Browse button and choose the floppy drive
containing the SDA Logger installation disk.
4. Double click the Setup.exe icon when it appears.
5. Click the OK button to run the Setup.exe program.
6. Follow the installation instructions as prompted.
5. Click the OK button to run the Setup.exe program.
6. Follow the installation instructions as prompted.
Uninstall
Uninstall for the SDA Logger version is different for each
Windows operating system. Below are the methods for uninstalling
the SDA Logger.
Windows 3.11
the SDA Logger.
Windows 3.11
1. Open the File Manager in the Control Panel.
2. Click the drive that SDA Logger was installed to.
3. Click the SDA16 directory.
4. Double click the UNWISE.EXE.
5. Follow the Uninstall Wizard.
2. Click the drive that SDA Logger was installed to.
3. Click the SDA16 directory.
4. Double click the UNWISE.EXE.
5. Follow the Uninstall Wizard.
Windows 9x & Windows NT
1. Open Start | Settings | Control Panel.
2. Open ADD/REMOVE PROGRAMS.
3. Click SDA LOGGER.
4. Click the Add/Remove button.
5. Follow the Uninstall Wizard.
2. Open ADD/REMOVE PROGRAMS.
3. Click SDA LOGGER.
4. Click the Add/Remove button.
5. Follow the Uninstall Wizard.
Getting Started
This section will provide a quick example using the 485SDA10
and the demonstration program. If you experience any problems,
refer to Chapter 2 for more precise information on connections. The
demo program continually reads the A/D inputs and the digital I/O.
The states of the digital outputs can be toggled using F2, F3, and
F4. The serial port is configured for 9600 baud, 8 data bits, no
parity, and 1 stop bit. The program supports standard addresses
and IRQ’s for COM1 and COM2.
refer to Chapter 2 for more precise information on connections. The
demo program continually reads the A/D inputs and the digital I/O.
The states of the digital outputs can be toggled using F2, F3, and
F4. The serial port is configured for 9600 baud, 8 data bits, no
parity, and 1 stop bit. The program supports standard addresses
and IRQ’s for COM1 and COM2.
•
Connect a 0 to 5V DC analog device to A/D input #0, or you
can connect a variable resistor as shown in Figure 1.3. The