Emerson E2 Manuel D’Utilisation

This screen and the other screens that follow it are used 

to set up dial-out sites for both daytime and nighttime 
operation, including specifying phone numbers and IP 
addresses. Use the 

 and  keys to cycle through 

the Setup screens.

In general, a controller reports alarms to any or all of 

four different sources:
1. The E2 Display Header

 Alarms that occur within a E2 may be reported to the 

header display at the top of the screen. When an alarm is 
reported to the display, the word “*ALARM*” flashes 
underneath the time at the top of the screen, as shown in 
the example below:

Each E2 has a single digital output that reacts to alarm 

reports. When an alarm is reported to this output, the out-
put turns ON and remains on until the alarm condition has 
returned to normal.
3. Dial-Out

Alarms may be sent to remote alarm receivers via the 

modem defined for the controller. Possible dial-out 
devices include a PC running UltraSite, a printer, a fax 
machine, and a digital pager. 

If multiple E2s exist on a network, you may choose to 

send alarms across the LonWorks Network so that they 
may be picked up by the Alarm Annunciator. 

Refer to Section 10.16.2 for information on how an 

Alarm Annunciator works. 

In a network with multiple E2s, it is often the case that 

certain sensors or transducer values will need to be used 
by all E2s. A good example of this is outside air tempera-
ture. There is no real need for every E2 to have its own 
outside air temperature sensor, and therefore it would be 
beneficial if a single sensor could be used by all E2s on the 
network.

Navigate to the Global Data screen from the Main 

Menu:

1.

Press 



 (System Configuration)

2.

Press 



 (Global Data) to open the Global Data