Bosch TTCAN Manuel D’Utilisation

BOSCH

- 33/77 -

Revision 1.6

TTCAN

 11.11.02

manual_about.fm

Any number of bits may be written to ‘0’ (cleared) at the same time. Bits that are written to ‘1’
remain unchanged.

Config Error
Set when an error is found in the Trigger List.

Application Watchdog
Set when the application watchdog was not served in time.

Watch Trigger
Set when a Watch Trigger became active (missing Reference Message).

Initialisation Watch Trigger
Set when an Initialisation Watch Trigger became active (no system start-up).

Note : The initialisation is restarted by resetting IWT.

Change of Error Level
Set when the Error Level changed.

Tx_Count Overflow
Set when the FSE sees more than Expected_Tx_Trigger in one Matrix Cycle.

Tx_Count Underflow
Set when the FSE sees less than Expected_Tx_Trigger in one Matrix Cycle.

Global Time Error
Set when Synchronisation Deviation SD exceeds specified limit SDL (level2 only).

Global Time Discontinuity
Set on discontinuity of the Global Time (Disc_Bit in the Reference Message).

Global Time Wrap
Set when a Global Time wrap occurred (from 0xFFFF to 0x0000).

Stop Watch Event
Set when a rising edge is detected at the STOP_WATCH_TRIGGER pin.

Time Mark Interrupt
Set when the selected time equals value in Time Mark register.

Start of Gap
Set when a Gap is detected (Next_is_Gap bit in the Reference Message).

Change of Synchronisation Mode
Set when the master to slave relation or the schedule synchronisation changed.

Start of System Matrix Cycle
Set when a new System Matrix Cycle has started.

Start of Basic Cycle
Set when a new Basic Cycle has started.

15

14

13

12

11

10

9

8

7

6

5

4

3

2

1

0

rw

rw

rw

rw

rw

rw

rw

rw

rw

rw

rw

rw

rw

rw

rw

rw