BMW III Manuel Du Propriétaire

Navigator III Owner’s Manual

PPendix

PPendix

Using the Navigator III in your

Automobile

To remove your Navigator III from the

motorcycle mount:

1. Use the security screwdriver to loosen the

screw.on.the.top.of.the.cradle.lock..

2.. Lift.the.cradle.lock.up.until.it.clicks..
3. Pull the Navigator III out of the mount.
4.. Slide.the.power.plug.to.the.left.to.

disconnect the power cable.

To install the Navigator III to the non-skid

friction mount:

1.. Align.and.slide.the.power.plug.on.the.

vehicle power cable to the right until fully

seated.

2. Slide the locking lever on the base to the

left (unlocked).

3. Slide the bottom of the Navigator III into

the base until it clicks into place.

4. Slide the locking lever to the right (locked).
5. Connect the vehicle power cable into a

vehicle power outlet.

6. Route the cable so it does not interfere

with vehicle operation.

Connecting to Your Computer

NOTE: Do not connect the USB cable

to your computer until you have loaded

the USB drivers using the enclosed

DVD-ROM.

To update your software, load additional maps,

or load Custom POIs, connect your Navigator

III to your computer using the USB cable

provided.

Step 1: Load the USB Drivers

Before connecting the USB cable to your

computer, place the enclosed DVD-ROM into

your computer’s DVD-ROM drive.
If the DVD-ROM does not start automatically,

click

Start

and then

Run

. Type the letter of

your DVD-ROM drive followed by “setup”

(example: “D:\setup”). Then press

Enter

Follow the on-screen instructions.