Beckett RWF40 CG15 Manuel D’Utilisation

CG15, CG25, CG50 Burner Manual

Check barometric damper or draft hood for proper 
operation.
Inspect boiler sections and system load piping for 
possible leaks. Make all necessary repairs.
Check all operating and safety controls on the boiler 
for proper installation and operation.
Perform all maintenance and tests according to the 
burner control manufacturer’s instructions (limits, 
controllers, low water cutoff, relief valves, feed 
valves, etc.)

Inspect all piping for leakage and proper installation.  
Perform necessary repairs to comply with all codes.

Insure that there are no combustible materials, 
fl ammable liquids or vapors in the vicinity of the 
heating appliance.
Verify that the combustion air supply is functioning 
properly, adequately sized, clean, and properly 
lubricated.

Follow the guidelines under Start the Burner to set the 
combustion levels using test instruments. 

 

3.

4.

5.

6.

1.

2.

Follow the control manufacturer’s instructions and verify 
that the control is functioning to specifi cations.  See 
Page 14 or 16 for appropriate sequence of operation 
and Items 8 through 10 on Page 28 for control system 
checks.  

Close all gas valves in the gas supply piping 
system. 
Turn off all electrical power to the burner. 
Protect the burner and controls from moisture and 
dirt. 

Examine ignition electrode inslators for cracks.
Examine ignition wires for worn insulation.
Examine ignition electrodes for wear.
Check ignition transformer functionality.
Verify that the head is centered in the airtube and 
that the head is not damaged.
Check inlet pressure to the gas train SSOVs.
Verify maximum recommended pipe lengths used in 
gas trains (Figure 8A/B)
Verify low fi re light-off rate (Table 3)

1.

2.
3.

1.
2.
3.
4.
5.

6.
7.

8.

(if used)

* Automotive chassis or bearing grease is satisfactory o-ring lubricant.