BLOOMFIELD WVOC-G136 Manuel D’Utilisation

18 

 
PRECAUTIONS 

Turn oven power switch to FAN 

     Allow 

oven 

to 

cool 

 
FREQUENCY   As 

Noted 

 
TOOLS  

 

 

Mild Detergent, Soft Cloth or Sponge 

     Plastic 

Scouring 

Pad 

 

 

 

 

 

Spray Bottle 

     Commercial 

Oven 

Cleaner/Degreaser 

 

 
1.  Turn oven power switch to FAN; remove racks and take to back 
 sink. 

 
2.  Let oven cool to 200°F.  If oven is cooler than 200°F, raise          
 

temperature to no more than 200°F. 

 
3.  Mix oven cleaner/degreaser per manufacturer’s directions.  Spray 
 

oven cleaner/degreaser solution onto soiled surfaces; then, close 

 

oven door and let stand for 5 min. 

 
4.  Open door slowly to allow steam to escape and allow oven to cool 
 completely. 

 
5.  Wipe oven surfaces with a soft cloth, rinse cloth as necessary. 

 
6.  Re-spray any remaining soiled areas and scrub with a plastic      
 scouring 

pad. 

 
7.  Rinse all surfaces with a clean soft cloth dampened with clean     
 water. 

 
8.  Wash, rinse, and sanitize oven racks and replace in oven. 

 
9.  Wipe exterior surfaces with a clean cloth dampened with clean    
 

water and a non-abrasive cleanser.  Rinse by wiping with a clean 

 

cloth dampened with clean water. 

 
HEAVY SOIL RECOVERY—As Needed 

 
1.  Turn oven power switch to FAN; remove racks and take to back 
 sink. 

 
2.  Let oven cool to 200°F.  If oven is cooler than 200°F, raise              
 

temperature to no more that 200°F. 

 
3. Spray 

Oven 

Cleaner/Degreaser 

full strength onto soiled surfaces; 

 

then, close  oven door and let stand for 5 min. 

 
4.  Open door slowly to allow steam to escape and allow oven to cool 
 completely. 

 
5.  Wipe oven surfaces with a soft cloth, rinse cloth as necessary. 

 
6.  Re-spray any remaining soiled areas and scrub with a plastic    
 scouring 

pad. 

 
7.  Rinse all surfaces with a clean soft cloth dampened with clean     
 water. 

 
8.  Wash, rinse, and sanitize oven racks and replace in oven. 

Use due care when cleaning 
near fan.  Blades are sharp. 

 

DO NOT splash or pour water 
onto control panel or wiring. 

 

Keep the ventilator fan      
running during any "hot      
surface" cleaning operation to 
avoid a build-up of heat and/
or smoke. 
 
IMPORTANT:  Avoid Fire 
Suppression System          
discharge! 
Keep the ventilator fan      
running during any "hot      
surface" cleaning operation to 
avoid melting a fusible link 
and causing a discharge of 
the fire suppression media. 
 
IMPORTANT: 
Always rub / wipe in the     
direction of the polish lines   
or grain of the metal.