Whirlpool Roper RME30000 Manuel D’Utilisation
8
OVEN USE
Odors and smoke are normal when the oven is used the first few
times, or when it is heavily soiled.
times, or when it is heavily soiled.
IMPORTANT:
The health of some birds is extremely sensitive to
the fumes given off. Exposure to the fumes may result in death to
certain birds. Always move birds to another closed and well
ventilated room.
certain birds. Always move birds to another closed and well
ventilated room.
Electronic Clock/Timer
(on some models)
Display
When power is first supplied to the appliance, everything on the
display will light up for 5 seconds. Then “PF” will appear on the
display.
display will light up for 5 seconds. Then “PF” will appear on the
display.
If “PF” appears at any other time, a power failure has occurred.
Reset the clock. See “Clock” section.
Reset the clock. See “Clock” section.
When the oven is not in use, the display will show the time of day.
Clock
This is a 12-hour clock and does not show a.m. or p.m.
To Set:
Before setting, make sure the oven and Timer are off.
1.
Press CLOCK.
The colon will flash during Clock programming.
2.
Press the “up” or “down” arrow pads to set the time of day.
The time can be changed in either small or 10-minute
increments by pressing a pad briefly or by pressing and
holding a pad.
increments by pressing a pad briefly or by pressing and
holding a pad.
3.
Press CLOCK. The colon will stop flashing when the Clock is
active.
active.
Timer
The Timer can be set in minutes and seconds or hours and
minutes and counts down the set time. The Timer does not start
or stop the oven.
minutes and counts down the set time. The Timer does not start
or stop the oven.
To Set:
1.
Press TIMER.
The colon will flash during Timer programming.
2.
Press the “up” or “down” arrow pads to set length of time.
3.
Press TIMER.
The Timer will begin counting down 5 seconds after the time
is set.
is set.
To display the time of day while the Timer is counting down,
press CLOCK. Time of day will be displayed 5 seconds
before returning to the Timer countdown.
press CLOCK. Time of day will be displayed 5 seconds
before returning to the Timer countdown.
When there is one minute of time remaining, a single tone will
sound and the display will begin counting down in seconds.
sound and the display will begin counting down in seconds.
When the Timer reaches zero, the display will show “End”
and four 1-second tones will sound.
and four 1-second tones will sound.
To Cancel:
Press TIMER twice in the Timer mode.
Oven Temperature Control
IMPORTANT:
Do not use a thermometer to measure oven
temperature. Opening the oven door and element or burner
cycling may give incorrect readings.
cycling may give incorrect readings.
The oven provides accurate temperatures; however, it may cook
faster or slower than your previous oven, so the temperature
calibration can be adjusted. It can be changed in Fahrenheit only.
faster or slower than your previous oven, so the temperature
calibration can be adjusted. It can be changed in Fahrenheit only.
To Adjust Oven Temperature Calibration (on models with
manual oven control):
manual oven control):
1.
Make sure the oven temperature control knob is in the OFF
position. Pull oven temperature control knob straight off and
turn it over.
position. Pull oven temperature control knob straight off and
turn it over.
2.
Loosen the locking screws inside the oven temperature
control knob.
control knob.
1. Timer
2. Display
2. Display
3. Increase
4. Decrease
4. Decrease
5. Clock
5
4
1
3
2
1. Locking Screws
2. Notches
2. Notches
1
2