VTech IP Phone DS6472-6 Manuel D’Utilisation

106

This telephone system accommodates up to two cordless headsets. You 

can buy an additional cordless headset (

IS6100, purchased separately) for 

the telephone base. You can register a maximum of two headsets to the 

telephone base. The telephone base recognizes and counts a headset the 

same as a handset. The headset must be registered with the telephone base 

before use. You may need to charge the headset before registering it to the 

telephone base. For more details on battery charging, see page 6.

Place the non-registered headset in the headset charger and allow it to 

charge for at least 15 minutes before beginning registration. Remove the 

headset from the headset charger. The 

 light on the headset flashes 

slowly and alternately in red and blue.
On the telephone base, press and hold 

/FIND HANDSeT for about four 

seconds until the red 

IN USe light turns on.

Immediately place the headset in the headset charger. It takes about 

60 seconds to complete the registration. The red 

IN USe light on the 

telephone base turns off. The 

 light on the headset turns red when 

it is registered but not fully charged, or turns blue if it is registered and 

fully charged.

If the registration process is successful, you hear a dial tone when you press 

 on the headset. If the registration fails, you hear “

Not registered ” through 

the headset earpiece when you press   on the headset. The   light on the 

headset flashes slowly and alternately in red and blue. To reset the headset, 

remove it from the headset charger and then place it back into its charger. Try 

the registration process again.

1.

2.

3.

You cannot register a headset if any other system handset or headset is 

in use.
The headset must be deregistered before registering it to another 

telephone system.

•

•