VTech IP Phone DS6472-6 Manuel D’Utilisation

105

The handsets provided with your telephone system are already registered. 

Additional handsets registered to the telephone system are assigned 

in sequential order. For instance, if you already have 

HANDSeT 1 and 

HANDSeT 2, the new registered handset is assigned HANDSeT 3. This 

telephone system accommodates up to 12 handsets.

You can add new handsets (

DS6401, purchased separately) to your 

telephone system, but each handset must be registered with the telephone 

base before use. When first purchased, each expansion handset shows  

Put handset on BASe to register after a battery is installed. You may 

need to charge the handset before registering it to the telephone base. For 

more details on battery charging, see the table on page 5.
To register a handset:

Make sure the handset is out of the telephone 

base or handset charger and shows 

on BASe to register. Place the handset you wish 

to register in the telephone base.
The handset displays 

Registering handset... 

and the red 

IN USe light on the telephone base 

turns on. It takes about 90 seconds to complete 

the registration process. The handset displays 

HANDSeT X Registered (X represents the 

registered handset number). The 

IN USe light 

on the telephone base turns off and you hear 

a confirmation tone from the handset when 

registration completes.

If registration fails, the system will automatically try to 

register again. If registration fails after the third try, the 

handset displays 

Registration failed then Put handset 

on BASe to register and the telephone base beeps. 

This may take up to five minutes to occur. 
To reset the handset, remove it from the telephone 

base. When the handset displays 

BASe to register, try the registration process again.

1.

2.

You cannot register a handset if any other system 

handset is in use.

•