Proxim Tsunami MP.11 and MP.11a CPN 65755B Manuel D’Utilisation
Tsunami MP.11and MP.11a Installation and Management
CONFIGURATION RESTORE
You can restore the configuration of the MP.11/a by downloading a configuration file. The configuration
file contains the configuration information of an MP.11/a.
file contains the configuration information of an MP.11/a.
To download a configuration file through the Web Interface:
1. Set up the TFTP server as described in “TFTP Server Setup”
2. Access the MP.11/a as described in “Web Interface Overview”
3. Click
the
Commands button and the Download tab.
4. Fill in the following details:
Server IP Address <IP address TFTP server>
File Name <configuration file name>
File Type Config
File Operation Download
File Name <configuration file name>
File Type Config
File Operation Download
5. Click OK to start the file transfer.
The MP.11/a downloads the configuration file. The TFTP server program should show download activity
after a few seconds. When the download is complete and the system rebooted, the configuration is
restored.
after a few seconds. When the download is complete and the system rebooted, the configuration is
restored.
SOFT RESET TO FACTORY DEFAULT
If necessary, you can reset the MP.11/a to the factory default settings. Resetting to default settings
means that you must configure the MP.11/a anew.
means that you must configure the MP.11/a anew.
To reset to factory default settings using the Web Interface:
1. Click
the
Commands button and the Reset tab.
2. Click
the
Reset to Factory Default button.
The device configuration parameter values are reset to their factory default values.
If you do not have access to the MP.11/a, you can use the procedure described in “Hard Reset to
Factory Default” on page 106
Factory Default” on page 106
as an alternative.
Chapter 7. Procedures
105
CPN 65755
Issue Date: August 2003