Argox OS-214 plus Manuel D’Utilisation

11. Close the top cover and turn on the printer or press the

"FEED" button if the printer is already on.

Note: The "FEED" button does not make the printer cut. Cutting

occurs only when the software is properly set.

Configuration

This section discusses calibration, printing configuration and
resetting the printer to factory defaults.

Performing Calibration

1. Press and hold the feed button while turning on the power,

until the printing motor is activated.

2. Calibration is

performed while the printer automatically

feeds the label stock for a certain length.

Important! You must always carry out calibration when

changing media. Failure to do so will result in
improper detection by the label sensor.

Printing a Configuration Report

1. Press and hold the "Feed" button while turning on the

power, until the printing motor is activated.

2. After feeding 12-inches of blank media, the printing motor

suspends for one second and then prints

out a

configuration profile. The profile includes firmware version,
ROM checksum, RS232, thermal transfer/direct thermal
settings, hardware configuration, and font types.

3. At PPLB emulation, the printer enters character dump

mode. To exit from dump mode, press the feed button
again.