Argox OS-214 plus Manuel D’Utilisation

Resetting to Factory Default Settings

1. Turn on the printer and wait for 5 or more seconds.
2. Press the "Feed" button for 10 seconds, and the "Ready"

indicator and "Power" indicator will go off in order.

3. When the two indicators relight, release the feed button.
4. The printer feeds approximately 3 ~5 blank labels, and

then resets to the factory defaults.

Note: All settings are stored in flash and are retained even after

the printer is turned off.

Computer Connections

Note: You must insert the power supply’s barrel connector into

the power jack on the back of the printer before
connecting communication cables.

This printer comes with a USB interface, a nine-pin Electronics
Industries Association (EIA) RS-232 serial data interface and a
standard Centronics parallel interface. You must supply the
required interface cable for your application.

Note: This printer complies with FCC Rules and Regulations,

Part 15, for Class B Equipment, for use with fully shielded
six-foot data cables. Use of longer cables or unshielded
cables may increase radiated emissions above Class B
limits.

USB Interface Requirements

The Universal Serial Bus (USB) interface is version 2.0 and 1.1
compliant and provides a full-speed (12Mb/s) interface that is
compatible with your existing PC hardware. The USB’s “plug and
play” design makes installation easy. Multiple printers can share a
single USB port/hub.