Universal Electronics Thermostat 975 Manuel D’Utilisation
34
change or clean your air filter. The
factory set interval for
factory set interval for
CHNG
FLTR
to be displayed is 200 hours
of fan operation. This can be set
anywhere from 0 to 1950 hours in
25 hour increments. A selection of
anywhere from 0 to 1950 hours in
25 hour increments. A selection of
00
will cancel this feature.
When
CHNG FLTR
is displayed,
you can clear it by pressing the
FILTER button. This resets the
timer and starts counting the hours
until the next filter change.
FILTER button. This resets the
timer and starts counting the hours
until the next filter change.
The following steps will allow you
to change the number of hours for
filter change-out.
to change the number of hours for
filter change-out.
1. If you see
CHNG FLTR
on the
display, press the FILTER button
once to reset the timer. If you do not
see
once to reset the timer. If you do not
see
CHNG FLTR
proceed to step 2.
When the FILTER button is pressed
from heating to cooling as needed.
To set your thermostat to this
operating mode, press
To set your thermostat to this
operating mode, press
SYSTEM
button until
AUTO
is displayed on
the screen.
Pressing the
and
buttons at the same time will change
the setpoint temperature displayed
to the setpoint of the other mode.
This will allow you to modify both
the HEAT and COOL setpoints to
accommodate a HOLD condition
while in Automatic Changeover
mode.
the setpoint temperature displayed
to the setpoint of the other mode.
This will allow you to modify both
the HEAT and COOL setpoints to
accommodate a HOLD condition
while in Automatic Changeover
mode.
Air Filter
Air Filter
Air Filter
Air Filter
Air Filter
Change-Out Indicator.
Change-Out Indicator.
Change-Out Indicator.
Change-Out Indicator.
Change-Out Indicator.
Change-Out Indicator.
This feature allows the thermostat to
display the words
This feature allows the thermostat to
display the words
CHNG FLTR
(change filter) after a set time of fan
operation. This is a reminder to
operation. This is a reminder to
once, the display will show the
number of hours remaining before
number of hours remaining before
CHNG FLTR
indicator will
display.
2. Press the FILTER button. The
display will show
display will show
SET FILTER
TIME
and will show the number of
hours to filter change.
3. Press TIME
FWD
or TIME
BACK
to change the time to your
requirements.
4. Press PROGRAM
RUN
to
return to the normal operating mode.
NOTE: If unsure what interval to
use between filter changes or
cleaning, contact the manufacturer
of your heating/cooling equipment.
use between filter changes or
cleaning, contact the manufacturer
of your heating/cooling equipment.
Temporary Program Override.
Temporary Program Override.
Temporary Program Override.
Temporary Program Override.
Temporary Program Override.
Any time your program is running
and you would like to override it for
Any time your program is running
and you would like to override it for