Vieta VH-CD030 Manuel D’Utilisation

HIFI CD Player

 

VH-CD030

 

 

This page only contains suggestions for connection of your VH-CD030.
Note: that the accessories in the pictures on this page are not included in the supply.

1. Turn on and off the unit by 
pressing the mains switch.
2. Press the standby button on 
the remote control to switch 
into standby mode and power 
on again.
3. If you wish to turn off 
the unit to avoid any power 
consumption, you must press 
the mains switch.

  

 

Press the PLAY/PAUSE button once more to stop 
playback; the counter in the display will start to blink. 
To continue playback, press the PLAY/PAUSE button 
again.

To stop playback completely, press the STOP button 
once.
The display will display all the number of tracks on the 
disc and the total playback time.

When a CD track is being played it is possible to switch 
to the previous track or to the next track.
If you want to continue to the next track, you must 
press the >>l button on the remote control or on the
front panel once. If you want to move on several tracks, 
you must press >>I until you reach the track desired.
If you wish to go back to one of the previous tracks, you 
must use the same procedure but not the same button. 
Use the >>I button instead.

If you wish to search forward, depress the >> button 
on the remote until you get to that part of the track that 
you wish to hear, and then press play. You will see that 
the time counter in the display counts up very quickly.
If you wish to search backward, use the same 
procedure as when you search forward, but use the << 
button instead.

It is possible to select random play by pressing the 
RANDOM button on the remote control or the front 
panel. The CD tracks will be played in random order. 
The dash between the first and second number from 
the left starts to flash when this functiopn has been 
activated.
It is possible to activate random play both in stop mode 
and during playback.
Press the RANDOM button again if you wish to 
deactivate random play.

Note: When you press SKIP buttons ( l<< or >>l) during 
random play, it will not be possible to select the next 
track but any other track.

If you want to play a disc, you must load it. You do that 
by pressing the eject button on the remote control or 
on the front panel of the CD player.
When the disc has been read, the display will show the 
number of tracks on the disc and the total playback 
time.
If there is not disc in the tray, the message “NO DISC” 
will be displayed. If the unit has trouble reading a disc, 
you must check if the disc is clean and free from dirt. 
If the disc can still not be played, you must contact your 
dealer.

4. Protect the environment and 
turn off the unit after use.

Press the PLAY/PAUSE button on the remote control or 
on the front panel once to start playback; the counter 
on the left side of the display will start to count upward.