Quadra-Fire CB1200-B Manuel De Montage

R 

September 1, 2008

7014-082D

Page  19

1.  Remove the baffle first, follow instructions on page 33.

2.  Slide bottom of left rear brick in first; rotate top edge 

toward rear of appliance and then rotate outer edge 
toward rear of appliance, until brick slides into place. 
Figure 19.1.

3.  Repeat with right rear brick. 

4.  Place left side brick along left side of firebox, making sure 

chamfered (beveled) back edge of brick fits snugly next 
to rear brick. Figure 19.2.

5.  Repeat with right side panel. 

6.  Complete brick set, correctly installed. Figure 19.3.

1

2

3

1

2

3

4

1.  After the brick set has been installed, 2 brick clips need 

to be installed on the outer edge of each baffle to hold 
the brick set in place.

2.  Remove 2 baffles from the appliance. Slide the baffle up 

and the bottom edge should fall down and then lift the 
baffle out.

3.  Using pliers, bend the brick clip slightly past 90° in the 

direction shown in Figure 19.4.

4.   Position the brick clip as shown in Figure 19.4  and use 

pliers to crimp around the outside edge of the baffle as 
shown in Figure 19.5. 

5.   Slide the baffle back into place making sure that the brick 

clip holds the side brick toward the wall of the firebox.  
Push back on the sides so they will keep the rear bricks 
in place.  Repeat for opposite side.

Approximately
 1 inch from corner

Top outside
corner of Baffle

Outside edge
of Baffle

Use pliers to crimp
Brick Clip around edge

•  Brick may have small wires protruding from 

the back of brick.

Risk of Injury.

1