Quadra-Fire CB1200-B Manuel De Montage

R 

September 1, 2008

7014-082D

Page  17

Flex Hose

Hose Clamp

Collar Assembly

Trim Ring

Termination
Cap Assembly

Hose Clamp

Included in Kit: 1 piece of 2 inch x 3 foot flex hose, 2 hose 
clamps, 1 collar assembly, termination cap assembly, 1 
trim ring, 12 screws. 

a.  Measure distance from floor to air vent opening in appli-

ance and mark location on wall.  

Use saw to cut opening in wall. Cut a 2-1/2 to 3 inch 

(64-76mm) opening on inside wall and a 3 to 3-1/2 inch 
(76-89mm) opening on outside of house.

b.  Use hose clamp to secure flex pipe to collar assembly.

c.  Slide trim ring over flex pipe and run pipe through wall.

d.  Attach hose to outside termination cap with second 

hose clamp.

e.  Secure termination cap to outside surface.

f. 

Secure trim ring to interior wall.

g.  Snip corners and remove plate. Figure 17.1. 

h.  Align and secure collar assembly with 2 of the 4 holes 

as shown.  Figure 17.2.

Tools Needed: Phillips head screw driver; wire cutters; 
hole saw or jig saw.

Never draw outside combustion air from:
•  Wall, floor or ceiling cavity
•  Enclosed space such as an attic or garage

a.  Remove rear screen and set aside.

b.  Install cover plate over hole in right rear floor.

c.  Cut a 2 inch minimum hole in the floor to accommodate 

flex hose.

d.  Attach hose to termination cap.

e.  Place rope under pedestal to close off air leaks.

Screen

Install Cover Plate

Seal Pedestal with 26 in. Rope

NO

NO

Secure Collar