Napoleon Grills PTH38PCP Manuel D’Utilisation
OPERATION
OPERATION
OPERATION
OPERATION
CAUTION
:
Avoid inhaling fumes emitted from the heater's
first use. Smoke and odor from the burning of oils used in
manufacturing will appear. Both smoke and odor will
dissipate after approximately 30 minutes. The heater
should NOT produce thick black smoke.
"
"
O W
NOTE:
When heater is ON:
"
"
O W
The burner may be noisy when initially turned on. To eliminate excessive
noise from the burner, turn the Control Knob to the LOW position. Then,
turn the knob to the level of heat desired.
noise from the burner, turn the Control Knob to the LOW position. Then,
turn the knob to the level of heat desired.
Emitter screen will become bright red due to intense heat. The color is more
visible at night. Burner will display tongues of blue flame. These flames
should not be yellow or produce thick black smoke, indicating an obstruction
of airflow through the burners.
visible at night. Burner will display tongues of blue flame. These flames
should not be yellow or produce thick black smoke, indicating an obstruction
of airflow through the burners.
RELIGHT
1)Turn the control knob to OFF position.
2)Wait five (5) minutes before attempting to relight pilot.
3) Repeat steps beginning with step 2 above.
2)Wait five (5) minutes before attempting to relight pilot.
3) Repeat steps beginning with step 2 above.
SHUT DOWN INSTRUCTIONS
1) Push in and turn control knob clockwise to "OFF" position.
2) Turn L.P. tank gas valve clockwise to "OFF" position when
heater is not in use
2) Turn L.P. tank gas valve clockwise to "OFF" position when
heater is not in use
WARNING :Heater will be hot after use.
Handle with extreme care.
Pus
h to
tu
rn
OFF
H
GI
H
LO
W
TO
LI
P
Pus
h to
tu
rn
OFF
H
GI
H
LO
W
TO
LI
P
The Event of Gas Leakage
"
"
O W
2)Turn LP cylinder to OFF position.
3)Wait 5 minutes to allow gas to dissipate.
4)If odor continues, immediately call gas supplier.
3)Wait 5 minutes to allow gas to dissipate.
4)If odor continues, immediately call gas supplier.
"
"
O W
1)Turn the control knob to OFF position.
If the flame is very small, this is because the supply pressure
is not enough.
is not enough.
Operation Pressure Checked
1)Turn the control knob to "OFF" position and Turn LP cylinder to
"OFF" position.
2)Never leave the patio heater unattended while in use.
"OFF" position.
2)Never leave the patio heater unattended while in use.
Before Leaving
12
Note: After use, some discoloration of the emitter screen is normal.
Warning:
White smoke may appear around the radiant head during the
first minutes of the initial firing.