Compaq 326817-003 Manuel D’Utilisation
Installation
2-3
Compaq Confidential – Need to Know Required
Writer: Debbie McRill Project: Compaq DAT AutoLoader Reference Guide Comments:
Part Number: 326817-003 File Name: c-ch2 Installation.doc Last Saved On: 1/25/00 10:01 AM
Setting the SCSI ID
Each SCSI device on the same SCSI bus must have a unique SCSI ID. Use the
jumper block located on the back of the DAT AutoLoader to set the SCSI ID.
For SCSI ID jumper settings see Table 2-2.
jumper block located on the back of the DAT AutoLoader to set the SCSI ID.
For SCSI ID jumper settings see Table 2-2.
Table 2-2
SCSI Jumper Pins
SCSI ID
Bit 2
Bit 1
Bit 0
0
0
0
0
1
0
0
1
2
0
1
0
3
0
1
1
4
1
0
0
5
1
0
1
6
1
1
0
7*
1
1
1
Note: SCSI ID 7 is reserved for the SCSI controller.
Switch Settings
When the DAT AutoLoader is powered on, it reads a set of configuration
switches on the underside of the drive. See the following sections for switch
descriptions and settings.
switches on the underside of the drive. See the following sections for switch
descriptions and settings.