Manualsbrain.com
  1. Manuels
  2. Marques
  3. Mocomtech
  4. CIM-550
  5. Manuel D’Utilisation

Mocomtech CIM-550 Manuel D’Utilisation

Télécharger
Page de 460
CiM-550 IP Enabled Satellite Modem 
Rev. 2 
CiM IP Module Checkout & Fault Isolation 
CD/CIM550.IOM 
424 
14.2.8 C
I
M 2 C
ONFIGURATION
 
Disconnect RJ-11 end of the console cable from CiM 1 and connect it to CiM 2. 
14.2.8.1 S
ETTING 
IP A
DDRESS
(
ES
) 
Step Procedure 
1 
From the Main Menu select Network Configuration sub-menu. 
2 
Set Ethernet IP Address to 172.17.10.10. 
3 
Set Subnet Prefix Length to 24. 
4 
Set HDLC IP Address to 10.1.1.2. 
5 
Set RX – Enable/Disable and TX – Enable/Disable to Enable. 
6 
From Receive HDLC Channel Address menu set HDLC Addr 1 to 1 (0x0001) 
The other parameters can be left to their factory default settings. At this point you should 
be able to ping CiM 2 from PC 2: 
7 
ping 172.17.10.10 
8 
ping 10.1.1.2 
 
14.2.8.2 R
OUTE 
T
ABLE
 
Step Procedure 
1 
From Transmitter Configuration, sub-menu select Route Table sub-menu. 
2 
Enter 1 to configure the first route 
3 
Enter a suitable name 
4 
Set IP Address to 172.16.10.0 
5 
Set Number of Subnet Bits to 24 
6 
Enter the next hop IP address which is CiM 1’s HDLC IP Address, 10.1.1.1 
 
14.2.8.3 S
AVE 
C
ONFIGURATION
 
Save parameters to permanent storage. 
14.2.9 V
ERIFICATION
 
At this point the basic configuration is over and you should be able to: 
 
Ping PC 1 from PC 2 and vice versa 
 
Ping CiM 2 from PC 1 and vice versa 
 
Pass any other data between the 2 PCs 
If Pings are not successful, refer to section 14.3, Troubleshooting IP Module.