BENDIX BW2820 Manuel D’Utilisation

For dual-wheel assemblies, position the SmarTire

™

 by Bendix CVS LF tool approximately 2 inches 

(5 cm) away from the tire’s surface positioned at the center of the outboard tire’s sidewall opposite 
the valve stem. The transmission from the tool will pass through the outboard tire and provoke a 
data transmission from the sensor mounted on the inboard tire.  
 
NOTE:  Dual-wheel assemblies should always be mounted with valve stems 180° opposite 
each other.  

There are multiple user interfaces that can be used to program sensors into the system and a 
general description is found below.  For more detailed information, consult your system’s Owner’s 
Manual. 

1.  Enter the setup mode for your user interface.  Find and enter the “learn sensor” mode. 
 
2.  Select which sensor you’d like to replace. 

 

The user interface will indicate that it is searching for a sensor.  The sensor inside the tire 
for the wheel position to be programmed must now be provoked to transmit its ID.  
 

3.  Turn the SmarTire

™

 LF tool ON by pressing and holding the On/Off button for 2 seconds. 

 
4.  Press the On/Off/Mode Select button once to toggle the tool mode to the learn sensor 

function.  The LED under the head with the question mark must now be ON. 

 

5.  Hold the SmarTire

™

 LF tool pointed towards the tire’s sidewall adjacent to sensor’s location 

approximately 2” away from the tire’s surface. The sensor should be located at the valve 
stem with a rim label indicating its location. Do not touch the edge of the rim. 

 

 

6