BENDIX BW2820 Manuel D’Utilisation
6. Press and release the initiate/learn button once & hold LF initiator tool in position for 5
seconds until the 4 rapid beeps are heard. Do not hold down the initiate/learn button.
7. When completed correctly, the user interface should indicate “learn complete”.
Two possible error conditions are:
Learn Time Out: A learn transmission was not provoked fast enough and the
system timed out. Repeat the learn process.
Duplicate Sensor ID: The sensor ID that was programmed to the wheel position is
also programmed to another wheel position.
8. Repeat the steps above until you have completed programming all of the necessary tire
locations, then exit the user interface’s setup mode.
6.
VERIFYING CORRECT INSTALLATION
To ensure that the system is properly configured after new sensor ID numbers have been
programmed in the receiver, verify the programming by following the steps below:
programmed in the receiver, verify the programming by following the steps below:
1. Power-up the receiver by switching the ignition on.
2. Press the On/Off/Mode Select button once to toggle the tool mode back to the initiate
function. Check that the LED under the antenna symbol is now ON.
3. Place the LF initiator next to each sensor position and press the initiate/learn button to
cause each sensor to transmit ID number and tire data.
4. Check the display to confirm that the signal was received by the receiver (wheel position
on the screen should have changed to a dark symbol).
5. If a sensor’s transmission was not received, repeat step 2. If the problem persists, power
down the system and repeat the “Programming Sensor ID Number” process or consult the
troubleshooting section in the SmarTire
troubleshooting section in the SmarTire
™
Tire Pressure Monitoring System by Bendix CVS
Operator's Manual (BW2799).
FCC NOTICE
This device complies with Part 15 of the FCC Rules. The SmarTire
This device complies with Part 15 of the FCC Rules. The SmarTire
™
LF tool is a Part 15 low power
transmitter below 1705 kHz. The device has a rated RF power output of less than 0.2 micro Watts.
Due to the transmit frequency range and low level of output power the device is not subject to the
routine RF exposure valuation as per Section 2.1093 of the FCC rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.
Due to the transmit frequency range and low level of output power the device is not subject to the
routine RF exposure valuation as per Section 2.1093 of the FCC rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.
7