Elica ESR436SS Manuel De Montage
8
•
Set free the two blower springs from the top of the range hood
housing.
•
Flip the blower base to the rear face of the range hood.
•
Insert the two blower springs to the top of the range hood
housing, Secure it with the four mounting screws previously
released.
Installation to wall
Install framing for hood support
•
If drywall is present, mark the screw hole locations. Remove the
template.
•
Cut away enough drywall to expose 2 vertical studs at the holes
location indicated by the template. Intall two horizontal supports
at least 4” x 2” between two wall studs at the bottom and upper
mounting holes installation location.
•
The horizontal support must be flush with the room side of the
studs. Use cleats behind both sides of the support to secure wall
studs.
•
Reinstall dywall and refinish.
IMPORTANT:Framing must be capable of supporting 100 lbs.
View from rear
1” x 6” Min.
Mounting
Support
Centerline of
Installation
Space
Cleats
•
Cut holes at marked locations for duct and electrical wiring.
•
For the vertical duct, cut out
3⁄ 4
” extra toward the front of the cabi-
net so you can move the dut freely when installing the hood.
•
It may also easy installation by cutting the hole 10
1⁄2
” instead of
10”.
Install Range hood
•
Drive a mounting screw (from the hardware package) partway
into each center of the narrow neck of the keyhole slots marked
on the cabinet bottom or the wall’s support frame.
•
Install the 2 (wall installation) or 4 (cabinet installation 5 x 45 mm
mounting screws. Leave a
1⁄4
” (6.4 mm) gap between the wall
and the back of the screw head to slide range hood into place.
1
⁄
4
”
(6.4 mm)
1
⁄
4
”
(6.4 mm)
Wall Installation
Cabinet Installation
•
Fix the wiring conduit of the hood.
•
Slide the hood back against the cabinet/wall. Tighten the
mounting screws. Be sure the screw heads are in the narrow
neck of the keyhole slot.
•
In wall installations, mount the security screws as shown in the
image below.
Cabinet Installation
A
Wall installation
A
C
B
C
A. Mounting Screws
B. Lower security screws (Wall Installation)
C. Upper security screws (Wall Installation)
•
Connect Ductwork to hood.